Chapter 2 Privilege Level and Command Mode
Ethernet Switch CLI Reference Guide
20
2.2.2 Command Modes for Privilege Levels 13-14
If the session’s privilege level is 13-14, the allowed commands are in one of several modes.
Each command is usually in one and only one mode. If a user wants to run a particular
command, the user has to change to the appropriate mode. The command modes are organized
like a tree, and users start in enable mode. The following table explains how to change from
one mode to another.
Table 7 Command Modes for Privilege Levels 13-14 and the Types of Commands in Each One
MODE PROMPT COMMAND FUNCTIONS IN THIS MODE
enable sysname# Display current configuration, diagnostics, maintenance.
config sysname(config)# Configure features other than those below.
config-interface sysname(config-interface)# Configure ports.
config-mvr sysname(config-mvr)# Configure multicast VLAN.
config-route-
domain
sysname(config-if)# Enable and enter configuration mode for an IPv4 or IPv6
routing domain.
config-dvmrp sysname(config-dvmrp)# Configure Distance Vector Multicast Routing Protocol
(DVRMP).
config-igmp sysname(config-igmp)# Configure Internet Group Management Protocol (IGMP).
config-ma sysname(config-ma)# Configure an Maintenance Association (MA) in
Connectivity Fault Management (CFM).
config-ospf sysname(config-ospf)# Configure Open Shortest Path First (OSPF) protocol.
config-rip sysname(config-rip)# Configure Routing Information Protocol (RIP).
config-vrrp sysname(config-vrrp)# Configure Virtual Router Redundancy Protocol (VRRP).
Table 8 Changing Between Command Modes for Privilege Levels 13-14
MODE ENTER MODE LEAVE MODE
enable -- --
config configure exit
config-interface interface port-channel <port-list> exit
config-mvr mvr <1-4094> exit
config-vlan vlan <1-4094> exit
config-route-domain interface route domain <ip-address>/<mask-bits> exit
config-dvmrp router dvmrp exit
config-igmp router igmp exit
config-ospf router ospf <router-id> exit
config-rip router rip exit
config-vrrp router vrrp network <ip-address>/<mask-bits>
vr-id <1~7> uplink-gateway <ip-address>
exit
To Next Page
Loading...
Need help?
General
