ZyXEL Communications Ethernet Switch User Manual

Ethernet Switch CLI Reference Guide
123
CHAPTER 28
IGMP Filtering Commands
Use these commands to configure IGMP filters and IGMP filtering on the Switch.
28.1 Command Summary
The following section lists the commands for this feature.
Table 72 igmp-filtering Command Summary
COMMAND DESCRIPTION M P
show igmp-filtering profile Displays IGMP filtering profile settings. E 3
igmp-filtering Enables IGMP filtering on the Switch. Ports can only join
multicast groups specified in their IGMP filtering profile.
C13
no igmp-filtering Disables IGMP filtering on the Switch. C 13
igmp-filtering profile <name>
start-address <ip> end-address
<ip>
Sets the range of multicast address(es) in a profile.
name: 1-32 alphanumeric characters
C13
no igmp-filtering profile <name> Removes the specified IGMP filtering profile. You cannot
delete an IGMP filtering profile that is assigned to any ports.
C13
no igmp-filtering profile <name>
start-address <ip> end-address
<ip>
Clears the specified rule of the specified IGMP filtering profile. C 13
show interfaces config <port-
list> igmp-filtering
Displays IGMP filtering settings. E 3
interface port-channel <port-
list>
Enters config-interface mode for the specified port(s). C 13
igmp-filtering profile
<name>
Assigns the specified IGMP filtering profile to the port(s). If
IGMP filtering is enabled on the Switch, the port(s) can only
join the multicast groups in the specified profile.
C13
no igmp-filtering profile Prohibits the port(s) from joining any multicast groups if IGMP
filtering is enabled on the Switch.
C13

ZyXEL Communications Ethernet Switch Specifications

General

Brand	ZyXEL Communications
Model	Ethernet Switch
Category	Network Router
Language	English