Ethernet Switch CLI Reference Guide
313
CHAPTER 83
VLAN Trunking Commands
Use these commands to decide what the Switch should do with frames that belong to unknown
VLAN groups.
83.1 Command Summary
The following section lists the commands for this feature.
Table 177 vlan-trunking Command Summary
COMMAND DESCRIPTION M P
interface port-channel <port-
list>
Enters config-interface mode for the specified port(s). C 13
vlan-trunking Enables VLAN trunking on ports connected to other switches
or routers (but not ports directly connected to end users). This
allows frames belonging to unknown VLAN groups to go out
via the VLAN-trunking port.
C13
no vlan-trunking Disables VLAN trunking on the port(s). C 13
To Next Page
Loading...
Need help?
General
