Ethernet Switch CLI Reference Guide
225
CHAPTER 55
Port-based VLAN Commands
Use these commands to configure port-based VLAN.
 These commands have no effect unless port-based VLAN is enabled.
55.1 Command Summary
The following section lists the commands for this feature.
55.2 Command Examples
This example looks at the ports to which incoming traffic from ports 1 and 2 can be forwarded.
Table 125 egress Command Summary
COMMAND DESCRIPTION M P
show interfaces config <port-
list> egress
Displays outgoing port information. E 3
vlan-type <802.1q|port-based> Specifies the VLAN type. C 13
interface port-channel <port-
list>
Enters config-interface mode for the specified port(s). C 13
egress set <port-list> Sets the outgoing traffic port list for a port-based VLAN. C 13
no egress set <port-list> Removes the specified ports from the outgoing traffic port list. C 13
sysname# show interfaces config 1-2 egress
Port 1: Enabled egress ports cpu, eg1
Port 2: Enabled egress ports cpu, eg1-eg4
To Next Page
Loading...
Need help?
General
