Ethernet Switch CLI Reference Guide
285
CHAPTER 74
TACACS+ Commands
Use these commands to configure external TACACS+ (Terminal Access Controller Access-
Control System Plus) servers.
74.1 Command Summary
The following section lists the commands for this feature.
Table 160 tacacs-server Command Summary
COMMAND DESCRIPTION M P
show tacacs-server Displays TACACS+ server settings. E 3
tacacs-server host <index> <ip>
[auth-port <socket-number>] [key
<key-string>]
Specifies the IP address of the specified TACACS+ server.
Optionally, sets the port number and key of the TACACS+
server.
index: 1 or 2.
key-string: 1-32 alphanumeric characters
C14
tacacs-server mode <index-
priority|round-robin>
Specifies the mode for TACACS+ server selection. C 14
tacacs-server timeout <1-1000> Specifies the TACACS+ server timeout value. C 14
no tacacs-server <index> Disables TACACS+ authentication on the specified server. C 14
Table 161 tacacs-accounting Command Summary
COMMAND DESCRIPTION M P
show tacacs-accounting Displays TACACS+ accounting server settings. E 3
tacacs-accounting timeout <1-
1000>
Specifies the TACACS+ accounting server timeout value. C 13
tacacs-accounting host <index>
<ip> [acct-port <socket-number>]
[key <key-string>]
Specifies the IP address of the specified TACACS+
accounting server. Optionally, sets the port number and key of
the external TACACS+ accounting server.
index: 1 or 2.
key-string: 1-32 alphanumeric characters
C13
no tacacs-accounting <index> Disables TACACS+ accounting on the specified server. C 13
To Next Page
Loading...
Need help?
General
