Ethernet Switch CLI Reference Guide
63
CHAPTER 12
Cluster Commands
Use these commands to configure cluster management.
12.1 Command Summary
The following section lists the commands for this feature.
Table 35 cluster Command Summary
COMMAND DESCRIPTION M P
show cluster Displays cluster management status. E 3
cluster <vlan-id> Enables clustering in the specified VLAN group. C 13
no cluster Disables cluster management on the Switch. C 13
cluster name <cluster name> Sets a descriptive name for the cluster.
<cluster name>: You may use up to 32 printable
characters (spaces are allowed).
C13
show cluster candidates Displays the switches that are potential cluster members. The
switches must be directly connected.
E3
cluster member <mac> password
<password>
Adds the specified device to the cluster. You have to specify
the password of the device too.
C13
show cluster member Displays the cluster member(s) and their running status. E 3
show cluster member config Displays the current cluster member(s). E 3
show cluster member mac <mac> Displays the running status of the cluster member(s). E 3
cluster rcommand <mac> Logs into the CLI of the specified cluster member. C 13
no cluster member <mac> Removes the cluster member. C 13
To Next Page
Loading...
Need help?
General
