Chapter 29 Interface Commands
Ethernet Switch CLI Reference Guide
126
no flow-control Disables flow control on the port(s). C 13
no inactive Enables the port(s) on the Switch. C 13
no intrusion-lock Disables intrusion-lock on a port so that a port can be
connected again after you disconnected the cable.
C13
pvid <1-4094> The default PVID is VLAN 1 for all ports. Sets a PVID in
the range 1 to 4094 for the specified interface.
C13
qos priority <0-7> Sets the quality of service priority for an interface. C 13
speed-duplex <auto|10-half|10-
full|100-half|100-full|1000-
full>
Sets the duplex mode (
half or full) and speed (10,
100 or 1000 Mbps) of the connection on the interface.
Select
auto (auto-negotiation) to let the specified
port(s) negotiate with a peer to obtain the connection
speed and duplex mode.
C13
no interface <port-num> Resets the port counters for the specified port(s). E 13
show interfaces <port-list> Displays the current interface status for the specified
port(s).
E3
show interfaces config <port-list> Displays current interface configuration for the specified
port(s).
E3
Table 73 interface Command Summary (continued)
COMMAND DESCRIPTION M P
To Next Page
Loading...
Need help?
General
