ZyXEL Communications Ethernet Switch User Manual

Chapter 29 Interface Commands
Ethernet Switch CLI Reference Guide
127
29.2 Command Examples
This example looks at the current status of port 1.
The following table describes the labels in this screen.
sysname# show interfaces 1
Port Info Port NO. :1
Link :100M/F
Status :FORWARDING
LACP :Disabled
TxPkts :7214
RxPkts :395454
Errors :0
Tx KBs/s :0.0
Rx KBs/s :0.0
Up Time :127:26:26
TX Packet Unicast :7214
Multicast :0
Broadcast :163
Pause :0
Tagged :0
RX Packet Unicast :395454
Multicast :186495
Broadcast :200177
Pause :0
Control :0
TX Collison Single :0
Multiple :0
Excessive :0
Late :0
Error Packet RX CRC :0
Runt :0
Distribution 64 :285034
65 to 127 :31914
128 to 255 :22277
256 to 511 :50546
512 to 1023 :1420
1024 to 1518 :4268
Giant :0
Table 74 show interfaces
LABEL DESCRIPTION
Port Info
Port NO. This field displays the port number you are viewing.
Link This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps
or 1000M for 1000 Mbps) and the duplex (F for full duplex or H for half
duplex). It also shows the cable type (Copper or Fiber). This field displays
Down if the port is not connected to any device.
Status If STP (Spanning Tree Protocol) is enabled, this field displays the STP state
of the port. If STP is disabled, this field displays FORWARDING if the link is
up, otherwise, it displays STOP.
LACP This field shows if LACP is enabled on this port or not.
TxPkts This field shows the number of transmitted frames on this port

ZyXEL Communications Ethernet Switch Specifications

General

Brand	ZyXEL Communications
Model	Ethernet Switch
Category	Network Router
Language	English