EasyManuals Logo

ZyXEL Communications Ethernet Switch User Manual

ZyXEL Communications Ethernet Switch
360 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
Chapter 35 Link Layer Discovery Protocol (LLDP) Commands
Ethernet Switch CLI Reference Guide
168
35.2 Command Summary
The following section lists the commands for this feature.
Table 96 lldp Command Summary
COMMAND DESCRIPTION M P
interface port-channel <port-list> Enters config-interface mode for configuring the specified
port(s).
C13
lldp admin-status <tx-only|rx-
only|tx-rx>
Sets LLDP operating mode.
tx-only: the port(s) can only send LLDP packets.
rx-only: the port(s) can only receive LLDP packets.
tx-rx: the port(s) can send or receive LLDP packets.
C13
lldp basic-tlv management-
address
Enables the sending of Management Address TLVs on
the port(s).
C13
lldp basic-tlv port-description Enables the sending of Port Description TLVs on the
port(s).
C13
lldp basic-tlv system-
capabilities
Enables the sending of System Capabilities TLVs on the
port(s).
C13
lldp basic-tlv system-
description
Enables the sending of System Description TLVs on the
port(s).
C13
lldp basic-tlv system-name Enables the sending of System Name TLVs on the
port(s).
C13
lldp notification Enables the sending of LLDP traps. C 13
lldp org-specific-tlv dot1
port-protocol-vlan-id
Enables the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs, which contains the VLAN ID and
indicates whether the VLAN is enabled and supported.
C13
lldp org-specific-tlv dot1
port-vlan-id
Enables the sending of IEEE 802.1 Port VLAN ID TLVs,
which contains the port’s VLAN ID.
C13
lldp org-specific-tlv dot3
link-aggregation
Enables the sending of IEEE 802.3 Link Aggregation
TLVs, which shows the link aggregation status of the
port(s).
C13
lldp org-specific-tlv dot3 mac-
phy
Enables the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLV, which shows duplex and rate
settings and indicates whether auto negotiation is
supported on the port.
C13
lldp org-specific-tlv dot3 max-
frame-size
Enables the sending of IEEE 802.3 Maximum Frame
Size TLVs on the port(s).
C13
lldp org-specific-tlv dot3
power-via-mdi
Enables the sending of IEEE 802.3 Power via MDI TLVs,
which indicates whether power can be supplied via a
media dependent interface (MDI) on the port(s).
C13
no lldp admin-status Sets the port(s) to not send or receive LLDP packets. C 13
no lldp basic-tlv management-
address
Disables the sending of Management Address TLVs on
the port(s).
C13
no lldp basic-tlv port-
description
Disables the sending of Port Description TLVs on the
port(s).
C13
no lldp basic-tlv system-
capabilities
Disables the sending of System Capabilities TLVs on the
port(s).
C13
no lldp basic-tlv system-
description
Disables the sending of System Description TLVs on the
port(s).
C13

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZyXEL Communications Ethernet Switch and is the answer not in the manual?

ZyXEL Communications Ethernet Switch Specifications

General IconGeneral
BrandZyXEL Communications
ModelEthernet Switch
CategoryNetwork Router
LanguageEnglish

Related product manuals