Chapter 6 ARP Inspection Commands
Ethernet Switch CLI Reference Guide
37
The following table describes the labels in this screen.
Table 21 show arp inspection interface port-channel
LABEL DESCRIPTION
Interface This field displays the port number. If you configure the * port, the settings
are applied to all of the ports.
Trusted State This field displays whether this port is a trusted port (Trusted) or an
untrusted port (Untrusted).
Trusted ports are connected to DHCP servers or other switches, and the
switch discards DHCP packets from trusted ports only if the rate at which
DHCP packets arrive is too high.
Rate (pps) This field displays the maximum number for DHCP packets that the switch
receives from each port each second. The switch discards any additional
DHCP packets.
Burst Interval This field displays the length of time over which the rate of ARP packets is
monitored for each port. For example, if the Rate is 15 pps and the burst
interval is 1 second, then the switch accepts a maximum of 15 ARP packets
in every one-second interval. If the burst interval is 5 seconds, then the
switch accepts a maximum of 75 ARP packets in every five-second interval.