ZyXEL Communications ZyWall ATP series - Page 175

Chapter 6 Monitor
ZyWALL ATP Series User’s Guide
175
Figure 144 Monitor > Log > View Log
The following table describes the labels in this screen.
Table 69 Monitor > Log > View Log
LABEL DESCRIPTION
Show (Hide) Filter Click this button to show or hide criteria that allow you to filter logs that will be
displayed.
If the filter settings are hidden, the Category, Email Log Now, Refresh, and Clear fields
are available.
If the filter settings are shown, the Category, Priority, Source Address, Destination
Address, Source Interface, Destination Interface, Service, Keyword, Protocol and Search
fields are available.
Category Select the type of log message(s) you want to view. You can also view All Logs at one
time, or you can view the Debug Log.
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg, alert,
crit, error, warn, notice, and info, from highest priority to lowest priority. This field is
grayed out if the Category is Debug Log.
Source Address This displays when you show the filter. Type the source IP address of the incoming
packet that generated the log message. Do not include the port in this filter.
Destination Address This displays when you show the filter. Type the IP address of the destination of the
incoming packet when the log message was generated. Do not include the port in this
filter.
Source Interface This displays when you show the filter. Type the source interface of the incoming packet
that generated the log message.
Destination Interface This displays when you show the filter. Type the interface of the destination of the
incoming packet when the log message was generated.
Service This displays when you show the filter. Select the service whose log messages you would
like to see. The Web Configurator uses the protocol and destination port number(s) of
the service to select which log messages you see.