Chapter 9 Interfaces
ZyWALL ATP Series User’s Guide
269
9.8 Bridge Interfaces
This section introduces bridges and bridge interfaces and then explains the screens for bridge interfaces.
Enable Proxy ARP Select this to allow the Zyxel Device to answer external interface ARP requests on behalf of
a device on its internal interface. Interfaces supported are:
•Ethernet
•VLAN
• Bridge
See Section 9.3.2 on page 228 for more information.
Add Click Add to create an IPv4 Address, an IPv4 CIDR (for example, 192.168.1.1/24) or an IPv4
Range (for example, 192.168.1.2-192.168.1.100) as the target IP address. The Zyxel Device
answers external ARP requests only if they match one of these inputted target IP addresses.
For example, if the IPv4 Address is 192.168.1.5, then the Zyxel Device will answer ARP
requests coming from the WAN only if it contains 192.168.1.5 as the target IP address.
Select an existing entry and click Remove to delete that entry.
Related Setting
Configure WAN
TRUNK
Click WAN TRUNK to go to a screen where you can set this VLAN to be part of a WAN trunk
for load balancing.
Configure Policy
Route
Click Policy Route to go to the screen where you can manually configure a policy route to
associate traffic with this VLAN.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
Table 105 Configuration > Network > Interface > VLAN > Add / Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
