Chapter 17 Layer 2 Isolation
ZyWALL ATP Series User’s Guide
369
Figure 258 Configuration > Network > Layer 2 Isolation > White List
The following table describes the labels in this screen.
17.3.1 Add/Edit White List Rule
This screen allows you to create a new rule in the white list or edit an existing one. To access this screen,
click the Add button or select an entry from the list and click the Edit button.
Note: You can configure up to 100 white list rules on the Zyxel Device.
Note: You need to know the IP address of each connected device that you want to allow to
be accessed by other devices when layer-2 isolation is enabled.
Table 148 Configuration > Network > Layer 2 Isolation > White List
LABEL DESCRIPTION
Enable White List Select this option to turn on the white list on the Zyxel Device.
Note: You can enable this feature only when the security policy is enabled.
Add Click this to add a new rule.
Edit Click this to edit the selected rule.
Remove Click this to remove the selected rule.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This field is a sequential value, and it is not associated with a specific rule.
Status This icon is lit when the rule is active and dimmed when the rule is inactive.
IP Address This field displays the IP address of device that can be accessed by the devices connected to
an internal interface on which layer-2 isolation is enabled.
Description This field displays the description for the IP address in this rule.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
