ZyXEL Communications ZyWall ATP series - 3.4 Stopping the Zyxel Device

Chapter 3 Hardware, Interfaces and Zones
ZyWALL ATP Series User’s Guide
69
The following table shows the default physical port and interface mapping for each model at the time
of writing.
The following table shows the default interface and zone mapping for each model at the time of
writing.
3.4 Stopping the Zyxel Device
Always use Maintenance > Shutdown > Shutdown or the shutdown command before you turn off the
Zyxel Device or remove the power. Not doing so can cause the firmware to become corrupt.
Table 13 Default Physical Port - Interface Mapping
PORT / INTERFACE P1 P2 P3 P4 P5 P6 P7 P8
• ATP500 ge1 ge2 ge3 ge4 ge5 ge6 ge7 ge8
• ATP200 sfp wan wan lan1 lan1 lan1 lan1
Table 14 Default Physical Port - Interface Mapping - ATP800
PORT /
INTERFACE
P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 P11 P12 P13 P14
ATP800 ge1 ge2 ge3 ge4 ge5 ge6 ge7 ge8 ge9 ge10 ge11 ge12 ge13 ge14
Table 15 Default Zone - Interface Mapping
ZONE / INTERFACE WAN LAN1 LAN2 DMZ OPT
NO
DEFAULT
ZONE
• ATP200
WAN1
WAN1_PPP
WAN2
WAN2_PPP
LAN1 LAN2 DMZ SFP
SFP_PPP
GE7
GE7_PPP
GE8
GE8_PPP
Table 16 Default Zone - Interface Mapping
ZONE / INTERFACE WAN LAN DMZ OPT NO DEFAULT ZONE
• ATP500
GE2
GE2_PPP
GE3
GE3_PPP
GE4
GE5
GE6 GE1
GE1_PPP
GE7
GE7_PPP
GE8
GE8_PPP
• ATP800
GE1
GE1_PPP
GE2
GE2_PPP
GE3
GE4
GE5 GE13
GE13_PPP
GE14
GE14_PPP
GE6~GE12
GE6_PPP~GE12_PPP