ZyXEL Communications ZyWall ATP series - Authentication Server

Chapter 37 System
ZyWALL ATP Series User’s Guide
738
Figure 503 Configuration > System > SNMP > Service Control Rule Add/Edit
The following table describes the labels in this screen.
37.12 Authentication Server
You can set the Zyxel Device to work as a RADIUS server to exchange messages with a RADIUS client,
such as an AP for user authentication and authorization. Click Configuration > System > Auth. Server tab.
The screen appears as shown. Use this screen to enable the authentication server feature of the Zyxel
Device and specify the RADIUS client’s IP address.
Table 323 Configuration > System > SNMP > Service Control Rule Add/Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the Zyxel Device using SNMP.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using SNMP.
Zone Select ALL to allow or prevent any Zyxel Device zones from being accessed using SNMP.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the Zyxel Device from the specified computers.
Select Deny to block the user’s access to the Zyxel Device from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.