Chapter 4 Quick Setup Wizards
ZyWALL ATP Series User’s Guide
91
Figure 72 VPN for Configuration Provisioning Express Wizard: Configuration
• My Address (interface): Select an interface from the drop-down list box to use on your Zyxel Device.
• Secure Gateway: Any displays in this field because it is not configurable in this wizard. It allows
incoming connections from the Zyxel Device IPSec VPN Client.
• Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password. Use 8
to 31 case-sensitive ASCII characters or 8 to 31 pairs of hexadecimal (“0-9”, “A-F”) characters.
Proceed a hexadecimal key with “0x”. You will receive a PYLD_MALFORMED (payload malformed)
packet if the same pre-shared key is not used on both ends.
• Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also specify a
subnet. This must match the remote IP address configured on the remote IPSec device.
• Remote Policy (IP/Mask): Any displays in this field because it is not configurable in this wizard.
4.4.3 VPN Settings for Configuration Provisioning Express Wizard - Summary
This screen has a read-only summary of the VPN tunnel’s configuration and commands you can copy
and paste into another ZLD-based Zyxel Device’s command line interface to configure it.
To Next Page
Loading...
Need help?
General
