Chapter 20 IPSec VPN
ZyWALL ATP Series User’s Guide
386
20.2.1 The VPN Connection Add/Edit Screen
The VPN Connection Add/Edit Gateway screen allows you to create a new VPN connection policy or
edit an existing one. To access this screen, go to the Configuration > VPN Connection screen (see
Section 20.2 on page 384), and click either the Add icon or an Edit icon.
References Select an entry and click References to open a screen that shows which settings use the entry.
See Section 9.3.4 on page 230 for an example.
# This field is a sequential value, and it is not associated with a specific connection.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
Name This field displays the name of the IPSec SA.
VPN Gateway This field displays the VPN gateway in use for this VPN connection.
Gateway IP
Version
This field displays what IP version the associated VPN gateway(s) is using. An IPv4 gateway may
use an IKEv1 or IKEv2 SA. An IPv6 gateway may use IKEv2 only.
Policy This field displays the local policy and the remote policy, respectively.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 155 Configuration > VPN > IPSec VPN > VPN Connection (continued)
LABEL DESCRIPTION
To Next Page
Loading...
