ZyXEL Communications ZyWall ATP series - Tunnel Add or Edit Screen

Chapter 9 Interfaces
ZyWALL ATP Series User’s Guide
252
9.6.2 Tunnel Add or Edit Screen
This screen lets you configure a tunnel interface. Click Configuration > Network > Interface > Tunnel >
Add (or Edit) to open the following screen.
IP Address This is the IP address of the interface. If the interface is active (and connected), the Zyxel
Device tunnels local traffic sent to this IP address to the Remote Gateway Address.
Tunnel Mode This is the tunnel mode of the interface (GRE, IPv6-in-IPv4 or 6to4). This field also displays the
interface’s IPv4 IP address and subnet mask if it is a GRE tunnel. Otherwise, it displays the
interface’s IPv6 IP address and prefix length.
My Address This is the interface or IP address uses to identify itself to the remote gateway. The Zyxel
Device uses this as the source for the packets it tunnels to the remote gateway.
Remote Gateway
Address
This is the IP address or domain name of the remote gateway to which this interface tunnels
traffic.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to begin configuring this screen afresh.
Table 102 Network > Interface > Tunnel (continued)
LABEL DESCRIPTION