ZyXEL Communications ZyWall ATP series - The Routing Traces Screen

Chapter 40 Diagnostics
ZyWALL ATP Series User’s Guide
790
40.8 The Routing Traces Screen
Click Maintenance > Diagnostics > Routing Traces to display this screen. Use this screen to configure a
traceroute to identify where packets are dropped for troubleshooting.
Figure 548 Maintenance > Diagnostics > Routing Traces
The following table describes the labels in this screen.
Mail Server Port Enter the same port number here as is on the mail server for mail traffic.
TLS Security Select this option if the mail server uses Transport Layer Security (TLS) for encrypted
communications between the mail server and the Zyxel Device.
STARTTLS Select this option if the mail server uses SSL or TLS for encrypted communications
between the mail server and the Zyxel Device.
Authenticate Server Select this if the Zyxel Device authenticates the mail server in the TLS handshake.
Mail From Type the email address from which the outgoing email is delivered. This address is used in
replies.
Mail To Type the email address to which the outgoing email is delivered.
SMTP Authentication Select this check box if it is necessary to provide a user name and password to the SMTP
server.
User Name This box is effective when you select the SMTP Authentication check box. Type the user
name to provide to the SMTP server when the log is emailed.
Password This box is effective when you select the SMTP Authentication check box. Type the
password to provide to the SMTP server when the log is emailed.
Retype to Confirm Retype your new password for confirmation.
Test Click this button to start the test.
Stop Click this button to stop the test.
Reset Click this button to return the screen to its last-saved settings.
Table 352 Maintenance > Diagnostics > Network Tool (continued)
LABEL DESCRIPTION
Table 353 Maintenance > Diagnostics > Routing Traces
LABEL DESCRIPTION
IP Address You can trace traffic through the Zyxel Device from a specific source-to-destination
stream or just from/to a specific host (source or destination).
Source Enter the source IP address of traffic that you want to trace.
Port Enter the source port number of traffic that you want to trace.