Chapter 6 Monitor
ZyWALL ATP Series User’s Guide
138
6.15 AP Information: AP List
The AP Information menu contains AP List, Radio List, Top N APs and Single AP screens. Click Monitor >
Wireless > AP Information to display the AP List screen.
Figure 112 Monitor > Wireless > AP Information > AP List
The following table describes the labels in this screen.
FQDN Object Select an object from the drop-down list box to display related IPv6 FQDN object
caches used in DNS queries.
# This is the index number of the IPv6 FQDN entry.
Name This field displays the name of the selected IPv6 FQDN object used in DNS queries.
FQDN This field displays a host’s fully qualified domain name.
IP Address This field displays the mapping of the FQDN to an IPv6 address. This is the IPv6 address
of a host.
TTL This field displays the number of seconds the Zyxel Device holds IP address - FQDN
object mapping in its cache. The mapping is updated when the TTL (Time To Live)
setting expires.
Refresh Click this button to update the information in the screen.
Table 41 Monitor > System Status > FQDN Object
LABEL DESCRIPTION
Table 42 Monitor > Wireless > AP Information > AP List
LABEL DESCRIPTION
Config AP Select an AP and click this to change the selected AP’s group, radio, VLAN and port
settings.
Add to Mgnt AP List Click this to add new Access Points
More Information Click this icon to see AP Information and Station count.
Reboot Select an AP and click this button to force it to restart.
DCS Now Select one or multiple APs and click this button to use DCS (Dynamic Channel
Selection) to allow the AP to automatically find a less-used channel in an
environment where there are many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile before
the APs can use DCS.
Note: DCS is not supported on the radio which is working in repeater AP
mode.
To Next Page
Loading...
