ZyXEL Communications ZyWall ATP series - Static DHCP Edit

Chapter 16 IP/MAC Binding
ZyWALL ATP Series User’s Guide
365
16.2.2 Static DHCP Edit
Click Configuration > Network > IP/MAC Binding > Edit to open the IP/MAC Binding Edit screen. Click the
Add or Edit icon to open the following screen. Use this screen to configure an interface’s IP to MAC
address binding settings.
Figure 254 Configuration > Network > IP/MAC Binding > Edit > Add
The following table describes the labels in this screen.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
# This is the index number of the static DHCP entry.
IP Address This is the IP address that the Zyxel Device assigns to a device with the entry’s MAC
address.
MAC Address This is the MAC address of the device to which the Zyxel Device assigns the entry’s IP
address.
Description This helps identify the entry.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
Table 144 Configuration > Network > IP/MAC Binding > Edit (continued)
LABEL DESCRIPTION
Table 145 Configuration > Network > IP/MAC Binding > Edit > Add
LABEL DESCRIPTION
Interface Name This field displays the name of the interface within the Zyxel Device and the interface’s IP
address and subnet mask.
IP Address Enter the IP address that the Zyxel Device is to assign to a device with the entry’s MAC
address.
MAC Address Enter the MAC address of the device to which the Zyxel Device assigns the entry’s IP
address.
Description Enter up to 64 printable ASCII characters to help identify the entry. For example, you may
want to list the computer’s owner.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.