Chapter 37 System
ZyWALL ATP Series User’s Guide
744
The following table describes the labels in this screen.
37.17 Zyxel One Network (ZON) Utility
The Zyxel One Network (ZON) utility uses the Zyxel Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware Zyxel devices in the same broadcast domain as the computer on which ZON is
installed.
The ZON Utility issues requests via ZDP and in response to the query, the Zyxel device responds with basic
information including IP address, firmware version, location, system and model name. The information is
then displayed in the ZON Utility screen and you can perform tasks like basic configuration of the
devices and batch firmware upgrade in it. You can download the ZON Utility at www.zyxel.com and
install it on a computer.
37.17.1 Requirements
Before installing the ZON Utility on your computer, please make sure it meets the requirements listed
below.
Operating System
At the time of writing, the ZON Utility is compatible with:
• Windows 7 (both 32-bit / 64-bit versions)
• Windows 8 (both 32-bit / 64-bit versions)
• Windows 8.1 (both 32-bit / 64-bit versions)
• Window 10 (both 32-bit / 64-bit versions)
Note: To check for your Windows operating system version, right-click on My Computer >
Properties. You should see this information in the General tab.
Hardware
Here are the minimum hardware requirements to use the ZON Utility on your computer.
• Core i3 processor
•2GB RAM
• 100MB free hard disk
• WXGA (Wide XGA 1280x800)
Table 329 Configuration > System > IPv6
LABEL DESCRIPTION
Enable IPv6 Select this to have the Zyxel Device support IPv6 and make IPv6 settings be available on
the screens that the functions support, such as the Configuration > Network > Interface >
Ethernet, VLAN, and Bridge screens. The Zyxel Device discards all IPv6 packets if you clear
this check box.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
