ZyXEL Communications ZyWall ATP series - Page 178

Chapter 6 Monitor
ZyWALL ATP Series User’s Guide
178
Search Click this to start the search.
Email Log Now Click this button to send log message(s) to the Active email address(es) specified in the
Send Log To field on the Log Settings page.
Refresh Click this button to update the information in the screen.
Clear Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
# This field is a sequential value, and it is not associated with a specific log message.
Time This field displays the time the log message was recorded.
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg, alert,
crit, error, warn, notice, and info, from highest priority to lowest priority. This field is read-
only if the Category is Debug Log.
Category This field displays the log that generated the log message. It is the same value used in
the Display and (other) Category fields.
Message This field displays the message of the log.
Source This displays the source IP address of the selected log message.
Destination This displays the source IP address of the selected log message.
Note This field displays any additional information about the log message.
Table 70 Monitor > Log > View AP Log (continued)
LABEL DESCRIPTION