Chapter 8 Wireless
ZyWALL ATP Series User’s Guide
194
# This is the index number of the SSID profile. You can associate up to eight SSID profiles with
an AP radio.
SSID Profile Indicates which SSID profile is associated with this radio profile.
VLAN Settings
Force Overwrite
VLAN Config
Select this to have the Zyxel Device change the AP’s management VLAN to match the
configuration in this screen.
Management VLAN
ID
Enter a VLAN ID for this AP.
As Native VLAN Select this option to treat this VLAN ID as a VLAN created on the Zyxel Device and not one
assigned to it from outside the network.
Port Settings
Model Specific
Setting
Select the model of the managed AP to display the model-specific port and VLAN settings
in the tables below.
Port Setting You can activate or deactivate a non-uplink port.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Activate/Inactivate To turn on an entry, select it and click Activate. To turn off an entry, select it and click
Inactivate.
# This is the port’s index number in this list.
Status This displays whether or not the port is activated.
Port This shows the name of the physical Ethernet port on the managed AP.
PVID This shows the port’s PVID.
A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a port
so that the frames are forwarded to the VLAN group that the tag defines.
VLAN Configuration Use Add to create a new VLAN Configuration. Select a VLAN Configuration first to use the
Edit, Remove, Activate and Inactivate buttons.
# This is the VLAN’s index number in this list.
Status This displays whether or not the VLAN is activated.
Name This shows the name of the VLAN.
VID This shows the VLAN ID number.
Member This field displays the Ethernet port(s) that is a member of this VLAN.
Load Balancing
Setting
Enable Load
Balancing
Select this to enable load balancing on the Zyxel Device.
Use this section to configure wireless network traffic load balancing between the managed
APs in this group.
Note: Load balancing is not supported on the radio which is working in root AP or
repeater AP mode.
Table 80 Configuration > Wireless > AP Management > AP Group > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
