ZyXEL Communications ZyWall ATP series - Page 39

Chapter 1 Introduction
ZyWALL ATP Series User’s Guide
39
Configuration Menu
Use the configuration menu screens to configure the Zyxel Device’s features.
Log View Log Lists log entries.
View AP Log Lists AP log entries.
Table 7 Configuration Menu Screens Summary
FOLDER OR LINK TAB FUNCTION
Quick Setup Quickly configure WAN interfaces or VPN connections.
Licensing
Registration Registration Register the device and activate trial services.
Service View the licensed service status and upgrade licensed services.
Signature
Update
Signature Update signatures immediately or by a schedule.
Wireless
Controller Configuration Configure manual or automatic controller registration.
AP
Management
Mgnt AP List Edit or remove entries in the lists of APs managed by the Zyxel Device.
AP Policy Configure the AP controller’s IP address on the managed APs and
determine the action the managed APs take if the current AP
controller fails.
AP Group Create groups of APs, define their radio, VLAN, port and load
balancing settings.
Firmware Update the firmware on APs connected to your Zyxel Device.
MON Profile Rogue/Friendly AP
List
Configure how the Zyxel Device monitors rogue APs.
Auto Healing Auto Healing Enable auto healing to extend the wireless service coverage area of
the managed APs when one of the APs fails.
RTLS Real Time Location
System
Use the managed APs as part of an Ekahau RTLS to track the location
of Ekahau Wi-Fi tags.
Network
Interface Port Role Use this screen to set the Zyxel Device’s flexible ports such as LAN, OPT,
WLAN, or DMZ.
Ethernet Manage Ethernet interfaces and virtual Ethernet interfaces.
PPP Create and manage PPPoE and PPTP interfaces.
Cellular Configure a cellular Internet connection for an installed mobile
broadband card.
Tunnel Configure tunneling between IPv4 and IPv6 networks.
VLAN Create and manage VLAN interfaces and virtual VLAN interfaces.
Bridge Create and manage bridges and virtual bridge interfaces.
VTI Configure IP address assignment and interface parameters for VTI
(Virtual Tunnel Interface).
Trunk Create and manage trunks (groups of interfaces) for load balancing.
Table 6 Monitor Menu Screens Summary (continued)
FOLDER OR LINK TAB FUNCTION