Chapter 23 BWM (Bandwidth Management)
ZyWALL ATP Series User’s Guide
440
Figure 302 Configuration > BWM > Create New Object > Add Address
The following table describes the fields in the above screen.
Table 180 Configuration > BWM > Create New Object > Add Address
LABEL DESCRIPTION
Name Enter a name for the Address object of the rule.
Address Type Select an Address Type from the drop down menu on the right. The Address Types
are Host, Range, Subnet, Interface IP, Interface Subnet, and Interface Gateway.
IP Address Enter an IP address for the Address object.
OK Click OK to save the setting.
Cancel Click Cancel to abandon the setting.
To Next Page
Loading...
