Chapter 34 Object
ZyWALL ATP Series User’s Guide
581
34.1.2.1 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone screen (see
Section 34.8.2 on page 633), and click the Add icon or an Edit icon.
Figure 377 Configuration > Object > Zone > Add
The following table describes the labels in this screen.
References Select an entry and click References to open a screen that shows which settings use the
entry. Click Refresh to update information in this screen.
# This field is a sequential value, and it is not associated with any interface.
Name This field displays the name of the zone.
Member This field displays the names of the interfaces that belong to each zone.
Reference This field displays the number of times an Object Reference is used in a policy.
Table 232 Configuration > Object > Zone (continued)
LABEL DESCRIPTION
Table 233 Configuration > Object > Zone > Add/Edit
LABEL DESCRIPTION
Name For a system default zone, the name is read only.
For a user-configured zone, type the name used to refer to the zone. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character cannot be
a number. This value is case-sensitive.
Member List Available lists the interfaces and VPN tunnels that do not belong to any zone. Select the
interfaces and VPN tunnels that you want to add to the zone you are editing, and click the
right arrow button to add them.
Member lists the interfaces and VPN tunnels that belong to the zone. Select any interfaces
that you want to remove from the zone, and click the left arrow button to remove them.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
