Chapter 34 Object
ZyWALL ATP Series User’s Guide
592
34.2.4.1 Default User Authentication Timeout Settings Edit Screens
The Default Authentication Timeout Settings Edit screen allows you to set the default authentication
timeout settings for the selected type of user account. These default authentication timeout settings
also control the settings for any existing user accounts that are set to use the default settings. You can
still manually configure any user account’s authentication timeout settings.
To access this screen, go to the Configuration > Object > User/Group > Setting screen (see Section 34.2.4
on page 589), and click one of the Default Authentication Timeout Settings section’s Edit icons.
Figure 383 Configuration > Object > User/Group > Setting > Edit
User Logon Settings
Limit the number of
simultaneous logons for
administration account
Select this check box if you want to set a limit on the number of simultaneous
logins by admin users. If you do not select this, admin users can login as many
times as they want at the same time using the same or different IP addresses.
Maximum number per
administration account
This field is effective when Limit ... for administration account is checked. Type
the maximum number of simultaneous logins by each admin user.
Limit the number of
simultaneous logons for
access account
Select this check box if you want to set a limit on the number of simultaneous
logins by non-admin users. If you do not select this, access users can login as
many times as they want as long as they use different IP addresses.
Maximum number per
access account
This field is effective when Limit ... for access account is checked. Type the
maximum number of simultaneous logins by each access user.
User Lockout Settings
Enable logon retry limit Select this check box to set a limit on the number of times each user can login
unsuccessfully (for example, wrong password) before the IP address is locked
out for a specified amount of time.
Maximum retry count This field is effective when Enable logon retry limit is checked. Type the
maximum number of times each user can login unsuccessfully before the IP
address is locked out for the specified lockout period. The number must be
between 1 and 99.
Lockout period This field is effective when Enable logon retry limit is checked. Type the number
of minutes the user must wait to try to login again, if logon retry limit is enabled
and the maximum retry count is reached. This number must be between 1 and
65,535 (about 45.5 days).
Apply Click Apply to save the changes.
Reset Click Reset to return the screen to its last-saved settings.
Table 239 Configuration > Object > User/Group > Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
