ZyXEL Communications ZyWall ATP series - Page 610

Chapter 34 Object
ZyWALL ATP Series User’s Guide
610
Case (Account) Select the case (upper or lower) the external server requires for letters in the account MAC
addresses.
Delimiter (Calling
Station ID)
RADIUS servers can require the MAC address in the Calling Station ID RADIUS attribute.
Select the separator the external server uses for the pairs in calling station MAC addresses.
Case (Calling
Station ID)
Select the case (upper or lower) the external server requires for letters in the calling station
MAC addresses.
802.1X Select this to enable 802.1x secure authentication.
Auth. Method This field is available only when you set the RADIUS server type to Internal.
Select an authentication method if you have created any in the Configuration > Object >
Auth. Method screen.
Reauthenticatio
n Timer
Enter the interval (in seconds) between authentication requests. Enter a 0 for unlimited
requests.
The following fields are available if you set Security Mode to wep.
Idle Timeout Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
Authentication Type Select a WEP authentication method. Choices are Open or Share key.
Key Length Select the bit-length of the encryption key to be used in WEP connections.
If you select WEP-64:
• Enter 10 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x11AA22BB33) for each Key used.
or
• Enter 5 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey) for each Key used.
If you select WEP-128:
• Enter 26 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x00112233445566778899AABBCC) for each Key used.
or
• Enter 13 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey12345678) for each Key used.
Key 1~4 Based on your Key Length selection, enter the appropriate length hexadecimal or ASCII key.
The following fields are available if you set Security Mode to wpa, wpa2 or wpa2-mix.
PSK Select this option to use a Pre-Shared Key with WPA encryption.
Pre-Shared Key Enter a pre-shared key of between 8 and 63 case-sensitive ASCII characters (including
spaces and symbols) or 64 hexadecimal characters.
Cipher Type Select an encryption cipher type from the list.
• auto - This automatically chooses the best available cipher based on the cipher in use
by the wireless client that is attempting to make a connection.
• tkip - This is the Temporal Key Integrity Protocol encryption method added later to the
WEP encryption protocol to further secure. Not all wireless clients may support this.
• aes - This is the Advanced Encryption Standard encryption method. It is a more recent
development over TKIP and considerably more robust. Not all wireless clients may
support this.
Idle Timeout Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
Group Key Update
Timer
Enter the interval (in seconds) at which the AP updates the group WPA encryption key.
Table 250 Configuration > Object > AP Profile > SSID > Security Profile > Add/Edit Security Profile
LABEL DESCRIPTION