Chapter 34 Object
ZyWALL ATP Series User’s Guide
621
Figure 402 Configuration > Object > Address/Geo IP > Address
The following table describes the labels in this screen. See Section 34.6.2.1 on page 622 for more
information as well.
Table 258 Configuration > Object > Address/Geo IP > Address
LABEL DESCRIPTION
IPv4 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses the
settings of one of the Zyxel Device’s interfaces.
IPv4 Address This field displays the IPv4 addresses represented by each address object. If the object’s
settings are based on one of the Zyxel Device’s interfaces, the name of the interface displays
first followed by the object’s current address settings.
To Next Page
Loading...
