Chapter 34 Object
ZyWALL ATP Series User’s Guide
625
34.6.3.1 Address Group Add/Edit Screen
The Address Group Add/Edit screen allows you to create a new address group or edit an existing one. To
access this screen, go to the Address Group screen (see Section 34.6.3 on page 624), and click either
the Add icon or an Edit icon in the IPv4 Address Group Configuration or IPv6 Address Group
Configuration section.
Figure 406 IPv4/IPv6 Address Group Configuration > Add
The following table describes the labels in this screen.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific address group.
Name This field displays the name of each address group.
Description This field displays the description of each address group, if any.
Reference This displays the number of times an object reference is used in a profile.
Table 261 Configuration > Object > Address/Geo IP > Address Group (continued)
LABEL DESCRIPTION
Table 262 IPv4/IPv6 Address Group Configuration > Add
LABEL DESCRIPTION
Name Enter a name for the address group. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Description This field displays the description of each address group, if any. You can use up to 60
characters, punctuation marks, and spaces.
To Next Page
Loading...
