Chapter 35 Device HA
ZyWALL USG Series User’s Guide
676
Figure 446 Configuration > Device HA > Device HA Status
The following table describes the labels in this screen.
Table 294 Configuration > Device HA > Device HA Status
LABEL DESCRIPTION
Active Device Status This section displays information on the active Zyxel Device with an activated Device
HA Pro license.
Health Status This displays Off or On depending on whether Device HA Pro is disabled or enabled
on the active Zyxel Device.
S/N This displays the serial number of the active Zyxel Device.
Virtual MAC This displays the hardware MAC address of the active Zyxel Device with an
activated Device HA Pro license.
Synch Status This displays the synchronization progress, No Progress / Fail / Abort / Success / In
Progress, between the active Zyxel Device with an activated Device HA Pro license
and the passive Zyxel Device.
Passive Device Status This section displays information on the passive Zyxel Device with an activated
Device HA Pro license.
Health Status This displays Off or On depending on whether Device HA Pro is disabled or enabled
on the passive Zyxel Device.
S/N This displays the serial number of the passive Zyxel Device.
Virtual MAC This displays the hardware MAC address of the passive Zyxel Device.
Synch Status This displays the synchronization progress, No Progress / Fail / Abort / Success / In
Progress, between the passive Zyxel Device with an activated Device HA Pro license
and the active Zyxel Device.
Device HA Pro License These are the steps to activate a Device HA Pro license on your active and passive
Zyxel Devices.
1. See your Device HA Pro iCard. The card contains two keys.
2. Register your active and passive Zyxel Devices at myZyxel.
3. Activate the license by entering one key on the active Zyxel Device and the
other key on the passive Zyxel Device. It doesn’t matter which Zyxel Device is
actually active or passive as this is dynamic in Device HA Pro.
To Next Page
Loading...
