Chapter 13 Interfaces
ZyWALL / USG (ZLD) CLI Reference Guide
106
[no] network-selection {auto|home} Home network is the network to which you are originally subscribed.
Home has the 3G device connect only to the home network. If the
home network is down, the
ZyWALL / USG's 3G Internet connection
is also unavailable.
Auto is the default setting and allows the 3G device to connect to a
network to which you are not subscribed when necessary, for example
when the home network is down or another 3G base station's signal is
stronger. This is recommended if you need continuous Internet
connectivity. If you select this, you may be charged using the rate of a
different network.
[no] budget active Sets a monthly limit for the user account of the installed 3G card. You
can set a limit on the total traffic and/or call time. The ZyWALL / USG
takes the actions you specified when a limit is exceeded during the
month. Use the no command to disable budget control.
[no] budget time active <1..672> Sets the amount of time (in hours) that the 3G connection can be
used within one month. If you change the value, the ZyWALL / USG
resets the statistics. Use the no command to disable time budget
control.
[no] budget data active {download-
upload|download|upload} <1..100000>
Sets how much downstream and/or upstream data (in Mega bytes)
can be transmitted via the 3G connection within one month.
download: set a limit on the downstream traffic (from the ISP to the
ZyWALL / USG).
upload: set a limit on the upstream traffic (from the ZyWALL / USG to
the ISP).
download-upload: set a limit on the total traffic in both directions.
If you change the value, the ZyWALL / USG resets the statistics.
Use the no command to disable data budget control.
budget reset-day <0..31> Sets the date on which the ZyWALL / USG resets the budget every
month. If the date you selected is not available in a month, such as
30th or 31st, the ZyWALL / USG resets the budget on the last day of
the month.
budget reset-counters Resets the time and data budgets immediately. The count starts over
with the 3G connection’s full configured monthly time and data
budgets. This does not affect the normal monthly budget restart.
budget {log|log-alert}[recursive
<1..65535>]
Sets the ZyWALL / USG to create a log (log) or an alert log (log-alert)
when the time or data limit is exceeded. You can also specify how
often (from 1 to 65535 minutes) to generate a log or an alert.
no budget log Sets the ZyWALL / USG to not create a log when the time or data limit
is exceeded.
budget new-connection {allow|disallow} Sets to permit (allow) or drop/block (disallow) new 3G connections
when the time or data limit is exceeded.
budget current-connection {keep|drop} Sets to maintain the existing 3G connection (keep) or disconnect it
(drop) when the time or data limit is exceeded. You cannot set budget
new-connection to allow and budget current-connection to drop at
the same time.
If you set budget new-connection to disallow and budget current-
connection to keep, the ZyWALL / USG allows you to transmit data
using the current connection, but you cannot build a new connection if
the existing connection is disconnected.
Table 49 Interface Cellular Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
