ZyXEL Communications ZyWALL USG-Series - Bandwidth Management Commands Examples

Chapter 31 Bandwidth Management
ZyWALL / USG (ZLD) CLI Reference Guide
213
31.3 Bandwidth Management Commands Examples
The following example sets the priority code to 3 for packets in VLAN 1 that don’t match any other
BWM rule. BWM rule 1 marks matching outgoing traffic from VLAN 1 to priority code 4.
marked-interface interface vlan<1..4064> When a packet matches BWM criteria, choose the VLAN
interface(s) to which to apply the priority code using a
marked-interface command.
Marks matching outgoing traffic from the specfied VLAN
with the configured priority code.
marked-interface any Marks matching outgoing traffic from any VLAN with the
configured priority code.
marked-interface trunk trunk_name Marks matching outgoing traffic from the specfied trunk
with the configured priority code.
marked-interface none Doesn’t mark outgoing traffic with priority code for this
BWM rule.
Table 116 bwm Sub-commands (continued)
COMMAND DESCRIPTION
Router(config)# interface vlan1
Router(config-if-vlan)# priority-code 3
Router(config-bwm modify 1)# exit
Router(config)# bwm 1
Router(config-bwm modify 1)# vlan-priority-code 4
Router(config-bwm modify 1)# marked-interface interface vlan1
Router(config-bwm modify 1)# exit
Router(config)#