ZyXEL Communications ZyWALL USG-Series - Trunk Commands Input Values; Trunk Commands Summary

Chapter 14 Trunks
ZyWALL / USG (ZLD) CLI Reference Guide
116
14.3 Trunk Commands Input Values
The following table explains the values you can input with the interface-group commands.
14.4 Trunk Commands Summary
The following table lists the interface-group commands. You must use the configure
terminal
command to enter the configuration mode before you can use these commands. See
Table 57 on page 116 for details about the values you can input with these commands.
Table 57 interface-group Command Input Values
LABEL DESCRIPTION
group-name A descriptive name for the trunk.
ZyWALL / USG uses up to 31 characters (a-zA-Z0-9_-). The name cannot start with a number.
This value is case-sensitive.
interface-
name
The name of an interface, it could be an Ethernet, PPP, VLAN or bridge interface. The possible
number of each interface type and the abbreviation to use are as follows.
Ethernet interface: For some ZyWALL / USG models, use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your ZyWALL / USG model.
Other ZyWALL / USG models use a name such as wan1, wan2, opt, lan1, or dmz.
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your ZyWALL / USG model supports.
VLAN interface: vlanx, x = 0 - 4094
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces your
ZyWALL / USG model supports.
num The interface’s position in the trunk’s list of members <1..8>.
<CR> Carriage Return (the “enter” key).
Table 58 interface-group Commands Summary
COMMAND DESCRIPTION
show interface-group {system-default|user-
define|group-name}
Displays pre-configured system default trunks, your own user
configuration trunks or a specified trunk’s settings.
[no] interface-group group-name Creates a trunk name and enters the trunk sub-command mode where
you can configure the trunk. The
no command removes the trunk.
algorithm {wrr|llf|spill-over} Sets the trunk’s load balancing algorithm.
exit Leaves the trunk sub-command mode.
flush Deletes a trunk’s interface settings.
interface {num|append|insert num}
interface-name [weight <1..10>|limit
<1..2097152>|passive]
This subcommand adds an interface to a trunk. Sets the interface’s
number. It also sets the interface’s weight and spillover limit or sets it
to be passive.