Chapter 34 IDP Commands
ZyWALL / USG (ZLD) CLI Reference Guide
227
34.3.1.1 Example of Global Profile Commands
In this example we rename an IDP signature profile from “old_profile” to “new_profile”, delete the
“bye_profile” and show all base profiles available.
34.3.2 Editing/Creating IDP Signature Profiles
Use these commands to create a new IDP signature profile or edit an existing one. It is
recommended you use the web configurator to create/edit profiles. If you do not specify a base
profile, the default base profile is none.
Note: You CANNOT change the base profile later!
34.3.3 Signature Search
Use this command to search for signatures in the named profile.
Router# configure terminal
Router(config)# idp rename signature
old_profile new_profile
Router(config)# no idp signature bye_profile
Router(config)# show idp signature base profile
No. Base Profile Name
==============================================================
1 none
2 all
3 wan
4 lan
5 dmz
Router(config)#
Table 129 Editing/Creating IDP Signature Profiles
COMMAND DESCRIPTION
idp signature newpro [base {all | lan | wan |
dmz | none}]
Creates a new IDP signature profile called newpro. newpro uses the
base profile you specify. Enters sub-command mode. All the
following commands relate to the new profile. Use
exit to quit
sub-command mode.
[no] signature sid activate Activates or deactivates an IDP signature.
signature sid log [alert] Sets log or alert options for an IDP signature
no signature sid log Deactivates log options for an IDP signature
signature sid action {drop | reject-
sender | reject-receiver | reject-both}
Sets an action for an IDP signature
no signature sid action Deactivates an action for an IDP signature.
description description2 Describes the signature profile.
To Next Page
Loading...
