Chapter 46 Authentication Server
ZyWALL / USG (ZLD) CLI Reference Guide
301
46.2.1 Authentication Server Command Examples
The following example shows you how to enable the authentication server feature on the ZyWALL /
USG and sets a trusted RADIUS client profile. This example also shows you the authentication
server and client profile settings.
[no] description description Sets the description for the profile. The no command clears this
setting.
description: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 60 characters long.
show auth-server status Displays the ZyWALL / USG’s authentication server settings.
show auth-server trusted-client Displays all RADIUS client profile settings.
show auth-server trusted-client
profile_name
Displays the specified RADIUS client profile settings.
Table 182 Command Summary: Authentication Server (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# auth-server activate
Router(config)# auth-server trusted-client AP-1
Router(config-trusted-client-AP-1)# activate
Router(config-trusted-client-AP-1)# ip address 10.10.1.2 255.255.255.0
Router(config-trusted-client-AP-1)# secret 12345678
Router(config-trusted-client-AP-1)# exit
Router(config)# show auth-server status
activation: yes
authentication method: default
certificate: default
Router(config)# show auth-server trusted-client AP-1
Client: AP-1
Activation: yes
Description:
IP: 10.10.1.2
Netmask: 255.255.255.0
Secret: VQEq907jWB8=
Router(config)#
To Next Page
Loading...
