ZyXEL Communications ZyWALL USG-Series - Packet Flow Explore Commands Example

Chapter 58 Packet Flow Explore
ZyWALL / USG (ZLD) CLI Reference Guide
376
58.3 Packet Flow Explore Commands Example
The following example shows all routing related functions and their order.
The following example shows all SNAT related functions and their order.
The following example shows all SNAT related functions and their order.
The following example shows all activated 1-to-1 SNAT rules.
The following example shows all activated site-to-site VPN rules.
The following example shows all activated dynamic VPN rules.
The following example shows the default WAN trunk’s settings.
Router> show route order
route order: Policy Route, Direct Route, 1-1 SNAT, SiteToSite VPN, Dynamic VPN,
Static-Dynamic Route, Default WAN Trunk, Main Route
Router> show system snat order
snat order: Policy Route SNAT, 1-1 SNAT, Loopback SNAT, Default SNAT
Router> show system route policy-route
No. PR NO. Source Destination Incoming DSCP Service Nexthop Type
Nexthop Info
===========================================================================
Router> show system route nat-1-1
No. VS Name Source Destination Outgoing Gateway
===========================================================================
Router> show system route site-to-site-vpn
No. Source Destination VPN Tunnel
===========================================================================
Router> show system route dynamic-vpn
No. Source Destination VPN Tunnel
===========================================================================
Router> show system route default-wan-trunk
No. Source Destination Trunk
===========================================================================
1 any any trunk_ex