ZyXEL Communications ZyWALL USG-Series - Active-Passive Mode Device HA Command Example

Chapter 38 Device HA
ZyWALL / USG (ZLD) CLI Reference Guide
267
38.4.2 Active-Passive Mode Device HA Command Example
This example configures a ZyWALL / USG to be a master ZyWALL / USG for active-passive mode
device HA. There is a management IP address of 192.168.1.3 on lan1. wan1 and lan1 are
monitored. The synchronization password is set to “mySyncPassword”.
Router(config)# device-ha ap-mode lan1 manage-ip 192.168.1.3 255.255.255.0
Router(config)# device-ha ap-mode role master
Router(config)# device-ha ap-mode master sync authentication password mySyncPassword
Router(config)# device-ha ap-mode wan1 activate
Router(config)# device-ha ap-mode lan1 activate
Router(config)# device-ha activate