Chapter 15 Route
ZyWALL / USG (ZLD) CLI Reference Guide
126
network N3 because it doesn't know that there is a route through the same gateway R1 (via
gateway R2). The static routes are for you to tell the ZyWALL / USG about the networks beyond the
network connected to the ZyWALL / USG directly.
Figure 14 Example of Static Routing Topology
15.4 Static Route Commands
The following table describes the commands available for static route. You must use the
configure terminal command to enter the configuration mode before you can use these
commands. See Section Table 59 on page 119 for information on input values.
Table 62 Command Summary: Static Route
COMMAND DESCRIPTION
[no] ip route {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127>
Sets a static route. The no command deletes a static
route.
ip route replace {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127> with {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127>
Changes an existing route’s settings.
show ip route-settings Displays static route information. Use show ip route
to see learned route information. See Section 16.2.5
on page 132.
ip6 route destv6/prefix { ipv6_global_address |
ipv6_link_local | interface} [<0..127>]
Sets an IPv6 static route.
ip6 route destv6/prefix { ipv6_link_local interface}
[<0..127>]
Sets an IPv6 link local static route.
no ip6 route destv6/prefix { gatewayv6 | interface}
[<0..127>]
Deletes the specified IPv6 static route.
ip6 route replace destv6/prefix { gatewayv6 | interface}
[<0..127>] with destv6/prefix { gatewayv6 | interface}
[<0..127>]
Changes an existing IPv6 route’s settings.
[no] ip route control-virtual-server-rules activate Gives static routes priority over NAT virtual server
rules (1-1 SNAT). It also automatically gives policy
routes priority over NAT virtual server rules. Use the
no command to give NAT virtual server rules priority
over static routes.
show ip route control-virtual-server-rules Displays whether or not static routes have priority
over NAT virtual server rules (1-1 SNAT).
To Next Page
Loading...
