Chapter 7 Wireless LAN Profiles
ZyWALL / USG (ZLD) CLI Reference Guide
60
7.2.1 AP Profile Commands Example
The following example shows you how to set up the radio profile named ‘RADIO01’, activate it, and
configure it to use the following settings:
• 2.4G band with channel 6
• channel width of 20MHz
• a DTIM period of 2
• a beacon interval of 100ms
• AMPDU frame aggregation enabled
• an AMPDU buffer limit of 65535 bytes
• an AMPDU subframe limit of 64 frames
• AMSDU frame aggregation enabled
• an AMSDU buffer limit of 4096
• block acknowledgement enabled
• a short guard interval
• an output power of 100%
5g-support-speed {disable |
wlan_5g_support_speed}
Disables or sets the 5 GHz support rate.
The default is 6.0~54.0.
tx-mask chain_mask Sets the outgoing chain mask rate.
rx-mask chain_mask Sets the incoming chain mask rate.
[no] htprotection Activates HT protection for this profile. Use the no parameter to
disable it.
By default, this is disabled.
output-power wlan_power Sets the output power for the radio in this profile.
The default is 100%.
[no] ssid-profile wlan_interface_index
ssid_profile
Assigns an SSID profile to this radio profile. Requires an existing
SSID profile. Use the no parameter to disable it.
exit Exits configuration mode for this profile.
Table 12 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
