ZyXEL Communications ZyWALL USG-Series - SNMP Commands Examples

Chapter 52 System Remote Management
ZyWALL / USG (ZLD) CLI Reference Guide
336
52.8.4 SNMP Commands Examples
The following command sets a service control rule that allowed the computers with the IP
addresses matching the specified address object to access the specified zone using SNMP service.
The following command sets the password (secret) for read-write (rw) access.
The following command sets the IP address of the host that receives the SNMP notifications to
172.23.15.84 and the password (sent with each trap) to qwerty.
The following commands create an SNMPv3 rule and then displays the configured settings..
snmp-server v3user username description
authentication {md5 | sha} privacy {none | des |
aes} privilege {ro | rw}
Sets the authentication, privacy and privilege for an SNMPv3
user.
snmp-server version {v2c | v3} Sets the SNMP version for the ZyWALL / USG. The SNMP version
on the ZyWALL / USG must match the version on the SNMP
manager.
show snmp status Displays SNMP Settings.
show snmp-server v3user status Displays authentication, privacy and privilege for configured
SNMPv3 users.
Table 206 Command Summary: SNMP (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# snmp-server rule 11 access-group Example zone WAN action accept
Router# configure terminal
Router(config)# snmp-server community secret rw
Router# configure terminal
Router(config)# snmp-server host 172.23.15.84 qwerty
Router# configure terminal
Router(config)# snmp-server v3user username john authentication md5 privacy none
privilege rw
Router(config)# show snmp-server v3user status
SNMPv3 user profile: 1
username: john
authentication: md5
privacy: none
privilege: rw
Router(config)#