ZyXEL Communications ZyWALL USG-Series - Learned Routing Information Commands; Show Ip Route Command Example

Chapter 16 Routing Protocol
ZyWALL / USG (ZLD) CLI Reference Guide
132
16.2.5 Learned Routing Information Commands
This table lists the commands to look at learned routing information.
16.2.6 show ip route Command Example
The following example shows learned routing information on the ZyWALL / USG.
area IP virtual-link IP message-digest-key
<1..255> encrypted-authentication-key
Sets the MD5 ID in the specified virtual link
no area IP virtual-link IP message-digest-
key <1..255>
Clears the MD5 ID in the specified virtual link.
Table 68 router Commands: Virtual Links in OSPF Areas (continued)
COMMAND DESCRIPTION
Table 69 ip route Commands: Learned Routing Information
COMMAND DESCRIPTION
show ip route [kernel | connected | static | ospf | rip |
bgp]
Displays learned routing and other routing
information.
Router> show ip route
Flags: A - Activated route, S - Static route, C - directly Connected
O - OSPF derived, R - RIP derived, G - selected Gateway
! - reject, B - Black hole, L - Loop
IP Address/Netmask Gateway IFace Metric Flags Persist
===========================================================================
0.0.0.0/0 172.16.1.254 wan1 0 ASG -
10.59.0.0/24 0.0.0.0 ext-wlan 0 ACG -
127.0.0.0/8 0.0.0.0 lo 0 ACG -
172.16.1.0/24 0.0.0.0 wan1 0 ACG -
192.168.1.0/24 0.0.0.0 lan1 0 ACG -
192.168.2.0/24 0.0.0.0 lan2 0 ACG -
192.168.3.0/24 0.0.0.0 dmz 0 ACG -