Chapter 39 User/Group
ZyWALL / USG (ZLD) CLI Reference Guide
270
39.2 User/Group Commands Summary
The following table identifies the values required for many username/groupname commands.
Other input values are discussed with the corresponding commands.
The following sections list the username/groupname commands.
39.2.1 User Commands
The first table lists the commands for users.
Table 157 username/groupname Command Input Values
LABEL DESCRIPTION
username The name of the user (account). You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
groupname The name of the user group. You may use 1-31 alphanumeric characters, underscores(
_), or
dashes (-), but the first character cannot be a number. This value is case-sensitive. It cannot
be the same as the user name.
Table 158 username/groupname Commands Summary: Users
COMMAND DESCRIPTION
show username [username] Displays information about the specified user or about all users
set up in the ZyWALL / USG.
username username nopassword user-type {admin |
guest | limited-admin | user}
Creates the specified user (if necessary), disables the password,
and sets the user type for the specified user.
username username password password user-type
{admin | guest | limited-admin | user}
Creates the specified user (if necessary); enables and sets the
password; and sets the user type for the specified user.
password: You can use 1-63 printable ASCII characters, except
double quotation marks (“) and question marks (?).
username username user-type ext-user Creates the specified user (if necessary) and sets the user type
to Ext-User.
username username user-type mac-address Creates the specified user (if necessary) and sets the user type
to mac-address.
username username user-type ext-group-user
associated-aaa-server server_profile group-id id
Specifies the value of the AD or LDAP server’s Group
Membership Attribute that identifies the group to which the
specified ext-group-user type user account belongs.
username username encrypted-password <password> Sets the password for the specified user.
no username username Deletes the specified user.
username rename username username Renames the specified user (first username) to the specified
username (second username).
username username [no] description description Sets the description for the specified user. The
no command
clears the description.
description: You can use alphanumeric and
()+/
:=?!*#@$_%-
characters, and it can be up to 60 characters
long.
username username logon-time-setting <default |
manual>
Sets the account to use the factory default lease and
reauthentication times or custom ones.
To Next Page
Loading...
