Chapter 7 Wireless LAN Profiles
ZyWALL / USG (ZLD) CLI Reference Guide
62
7.4 SSID Profile Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
[no] wlan-monitor-profile
monitor_profile_name
Enters configuration mode for the specified monitor profile. Use the
no parameter to remove the specified profile.
[no] activate Makes this profile active or inactive.
By default, this is enabled.
description description Sets the description for the profile. You may use up to 60
alphanumeric characters, underscores (_), or dashes (-). This
value is case-sensitive
[no] 2g-scan-channel
wireless_channel_2g
Sets the broadcast band for this profile in the 2.4 Ghz frequency
range. Use the no parameter to disable it.
[no] 5g-scan-channel
wireless_channel_5g
Sets the broadcast band for this profile in the 5 GHz frequency
range. Use the no parameter to disable it.
scan-method scan_method Sets the channel scanning method for this profile.
scan-dwell <100..1000> Sets the duration in milliseconds that the device using this profile
scans each channel.
exit Exits configuration mode for this profile.
Table 14 Command Summary: Monitor Profile (continued)
COMMAND DESCRIPTION
Table 15 Input Values for General SSID Profile Commands
LABEL DESCRIPTION
ssid_profile_name The SSID profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
ssid The SSID broadcast name. You may use 1-32 alphanumeric characters,
underscores (
_), or dashes (-). This value is case-sensitive.
wlan_qos Sets the type of QoS the SSID should use.
disable: Turns off QoS for this SSID.
wmm: Turns on QoS for this SSID. It automatically assigns Access Categories to
packets as the device inspects them in transit.
wmm_be: Assigns the “best effort” Access Category to all traffic moving through
the SSID regardless of origin.
wmm_bk: Assigns the “background” Access Category to all traffic moving through
the SSID regardless of origin.
wmm_vi: Assigns the “video” Access Category to all traffic moving through the
SSID regardless of origin.
wmm_vo: Assigns the “voice” Access Category to all traffic moving through the
SSID regardless of origin.
vlan_iface The VLAN interface name of the controller (in this case, it is NXC5200). The
maximum VLAN interface number is product-specific; for the ZyWALL / USG,
the number is 512.
To Next Page
Loading...
