Chapter 8 Rogue AP
ZyWALL / USG (ZLD) CLI Reference Guide
71
8.4 Rogue AP Containment Commands
The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
The following table describes the commands available for rogue AP containment. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
8.4.1 Rogue AP Containment Example
This example contains the device associated with MAC address 00:13:49:11:11:12 then displays
the containment list for confirmation.
Table 23 Input Values for Rogue AP Containment Commands
LABEL DESCRIPTION
ap_mac Specifies the MAC address (in XX:XX:XX:XX:XX:XX format) of the AP to be
contained. The no command removes the entry.
Table 24 Command Summary: Rogue AP Containment
COMMAND DESCRIPTION
rogue-ap containment Enters sub-command mode for rogue AP containment.
[no] activate Activates rogue AP containment. Use the no parameter to
deactivate rogue AP containment.
[no] contain ap_mac Isolates the device associated with the specified MAC address.
Use the no parameter to remove this device from the
containment list.
exit Exits configuration mode for rogue AP containment.
show rogue-ap containment config Displays whether rogue AP containment is enabled or not.
show rogue-ap containment list Displays the rogue AP containment list.
Router(config)# rogue-ap containment
Router(config-containment)# activate
Router(config-containment)# contain 00:13:49:11:11:12
Router(config-containment)# exit
Router(config)# show rogue-ap containment list
no. mac
=====================================================================
1 00:13:49:11:11:12
To Next Page
Loading...
