Chapter 33 Anti-Virus
ZyWALL / USG (ZLD) CLI Reference Guide
224
33.4 Anti-virus Statistics
The following table describes the commands for collecting and displaying anti-virus statistics. You
must use the
configure terminal command to enter the configuration mode before you can use
these commands.
33.4.1 Anti-virus Statistics Example
This example shows how to collect and display anti-virus statistics. It also shows how to sort the
display by the most common destination IP addresses.
Table 125 Commands for Anti-virus Statistics
COMMAND DESCRIPTION
[no] anti-virus statistics collect Turn the collection of anti-virus statistics on or off.
anti-virus statistics flush Clears the collected statistics.
show anti-virus statistics summary Displays the collected statistics.
show anti-virus statistics collect Displays whether the collection of anti-virus statistics is turned on or off.
show anti-virus statistics ranking
{destination | destination6 |
source | source6 | virus-name}
Query and sort the anti-virus statistics entries by destination IP address, source
IP address, or virus name. virus-name: lists the most common viruses
detected.
source(6): lists the source IP addresses (IPv4 or IPv6) of the most virus-
infected files.
destination(6): lists the most common destination IP addresses (IPv4 or
IPv6) for virus-infected files.
Router(config)# anti-virus statistics collect
Router(config)# show anti-virus statistics collect
collect statistics: yes
Router(config)# show anti-virus statistics summary
virus detected: 0
Router(config)# show anti-virus statistics ranking destination
To Next Page
Loading...
