ZyXEL Communications ZyWALL USG-Series - Authentication Server Commands

Chapter 51 System
ZyWALL / USG (ZLD) CLI Reference Guide
323
51.7.1 Authentication Server Commands
The following table lists the authentication server commands you use to configure the ZyWALL /
USG’s built-in authentication server settings.
Table 196 Command Summary: Authentication Server
COMMAND DESCRIPTION
[no] auth-server activate Sets the ZyWALL / USG to act as an authentication server for other
RADIUS clients, such as APs. The
no command sets the ZyWALL /
USG to not act as an authentication server for other APs.
auth-server authentication
auth_method
Specifies an authentication method used by the authentication
server.
no auth-server authentication Resets the authentication method used by the authentication server
to the factory default (
default).
[no] auth-server cert
certificate_name
Specifies a certificate used by the authentication server (ZyWALL /
USG). The
no command resets the certificate used by the
authentication server to the factory default (
default).
certificate_name: The name of the certificate. You can use up to
31 alphanumeric and ;‘~!@#$%^&()_+[]{}’,.=-
characters.
[no] auth-server trusted-client
profile_name
Creates a trusted RADIUS client profile. The no command deletes
the specified profile.
profile-name: You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
[no] activate Enables the client profile. The
no command disables the profile.
[no] ip address ip
subnet_mask
Sets the client’s IP address and subnet mask. The no command
clears this setting.
[no] secret secret Sets a password as the key to be shared between the ZyWALL / USG
and the client. The
no command clears this setting.
[no] description description Sets the description for the profile. The no command clears this
setting.
description: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 60 characters long.
show auth-server status Displays the ZyWALL / USG’s authentication server settings.
show auth-server trusted-client Displays all RADIUS client profile settings.
show auth-server trusted-client
profile_name
Displays the specified RADIUS client profile settings.