Chapter 14 Trunks
ZyWALL / USG (ZLD) CLI Reference Guide
118
The following example creates a spill-over trunk for Ethernet interfaces ge1 and ge3, which will
apply to both incoming and outgoing traffic through the trunk. The ZyWALL / USG sends traffic
through ge1 until it hits the limit of 1000 kbps. The ZyWALL / USG sends anything over 1000 kbps
through ge3.
Router# configure terminal
Router(config)# interface-group spill-example
Router(if-group)# mode trunk
Router(if-group)# algorithm spill-over
Router(if-group)# interface 1 ge1 limit 1000
Router(if-group)# interface 2 ge3 limit 1000
Router(if-group)# loadbalancing-index total
Router(if-group)# exit
Router(config)#
To Next Page
Loading...
