Chapter 25 Secure Policy
ZyWALL / USG (ZLD) CLI Reference Guide
170
The following command displays the default IPv4 secure policy rule that applies to the WAN to
ZyWALL / USG packet direction. The secure policy rule number is in the rule’s priority number in the
global rule list.
Router(config)# show secure-policy WAN ZyWALL
secure-policy rule: 11
name: WAN_to_Device
description:
user: any, schedule: none
from: WAN, to: ZyWALL
source IP: any, source port: any
destination IP: any, service: Default_Allow_WAN_To_ZyWALL
log: no, action: allow, status: yes
connection match: no
content-filter profile: none
enable: no, log: by-profile
anti-spam profile: none
enable: no, log: by-profile
anti-virus profile: none
enable: no, log: by-profile
idp profile: none
enable: no, log: by-profile
ssl-inspection profile: none
enable: no, log: by-profile
app-patrol profile: none
enable: no, log: by-profile
To Next Page
Loading...
